On snap. The 245/45/17s don't rub (once I raised the Flex's up nearly an inch :p)

http://www.neurosybir.net/nkoan/imag...2263_sized.jpg

So, you're basically at stock ride hieght? :lol:

More or less at the moment. I guess I need to get those 255/40 tires so I can lower the car a bit more :p

Here's a pic from before I had to raise it up.

http://www.neurosybir.net/nkoan/imag...2256_sized.jpg

If I "launched" (and I use that term lightly) from anything harder than a granny launch from a stop, I would rub in the back badly.

The wheel whore approves :D

Hey, do I come over to your work place to photograph my car?

Just take a picture of the turbo.

Those look good :)

Somebody by the name of Chris (aka bruspeed) is playing his card close to his chest. Any word on the future champ of DSP?

If I understood what I heard at the meet last week, he's actually gonna be running an SM Camaro...

OH, and my tires came in... :twisted:

Sounds like you have a lunch project now.

Now in the center ring.....MikeK vs. bruspeed!..

Aw, I thought it was going to be an ESP Camaro.

Maybe he should just go straight to CP to compete with Lucas and two CP Mustangs.

Chris and his Father are gonna run it co-driver style!!! I should go take a look at it this weekend when I am down in G-ville.

Sneak a couple of pics for us ;) .

Any pictures yet? I'm still attempting to squeeze a couple more pennies out of my back side for event two/three, so I can be on new rubber.

Anybody know who currently has the fender rolling tool?

No pics yet... I'm lazy... I found a bad fender roller in my toolbox! A big ass rubber mallet! Works GREAT!!!! :lol: No tire rub!

Ummm, Josh does, down here, then I need it back real quick for my car. Then I can get it back up to Reno....

Thanks, figured I'd try the proper tool before going with the hammer.

I'll have borla headers installed by the end of the week. . . :)

^^^Nice Jeremiah!

I have the Crucial Springs in (they're sweet!) and the high flow catted mid-pipe should be here tomorrow. :)

Yep, now I can make even more noise with a minimal hp gain. Long live n/a! :lol:

I bet they add more power than the high flow cat I'm adding. I'm hoping to see a little better spool too though. :)

I've been sort of eyeballing the Rallitek PerfectPower6 ECU. . . it looks like that with a tune and high flow cat might net me a fair gain, from the testimonies I've been reading. . .

Here's the ultimate mod for 2007: Click here