AP V2 Mounting Possibility
 

After the meet, Silvio and I went out to Wal-Mart and Target to find something that would be good to mount an Accessport. I found a universal cell phone holder, and it works really well, it holds the thing really snug, and I bent the clip on the back to make it slide into the area below the middle vents. Then I remounted the OBD-II to above the plastic knee guard. I will have pics up tomorrow as soon as I leave the bed.

-Chris

I keep threatening to move that connector, but am too lazy to pull the panel off again. I actually wanted to cut one out of a car at pick and pull and splice in a second connector so I don't have to put it back for Smog. I am sure they would have a conniption if the plug was not in the stock location.

TTIWWP!

i know what you mean, but there are only two little tabs that hold it in. i did mine without removing the knee guard.

i dont know what that means...

here are the pictures.
http://farm4.static.flickr.com/3074/...aa084e82_b.jpg
http://farm4.static.flickr.com/3012/...ec8c31b9_b.jpg

TTIWWOP = This thread is worthless with out pics

Looks good man.

Looks clean.

you should send that to cobb and tell them to sell them on their site!




....with a percentage going to you of course....and maybe me for suggesting it :lol:

haha, i would, but cobb is highly against the adjustment or use of the accessport while driving, and this is somewhat of a violation of their policies.

Just tell them that its off unless the e brake is engaged.

^ maybe.. i tested it out today a bit more... and the mount is "autox able" so it can probably take some of the hardest turns without even moving.

You just need it hooked up to read live boost or something?

any live data, i especially like the fuel consumption option

That would be cool.

Here's my mounting solution:

AccessPORT v2 Mounted in car