yep, sperry is correct, 1.5:1 ratio column.
so we had to cut some nasty holes in the firewall to get the wrx ac/heater core to fit so i figured now would be the time to put some shiny thermotec heatshield on to cover up the holes as much as possible and keep as much engine heat out of the cabin as possible.
some more awesome bushings that i got from L&E Fabrication..
steering rack. easiest bushing to put on the entire car. the rack was kinda a pita to get installed because of some rust issues.
SuperPro ALK bushings
definitely helped to have the press for these guys. make sure the center hole is towards the ground when installing.
hydraulic ksport ebrake and wilwood brake proportion valve is 90% installed. just need to attached 2 flex stainless lines into the system but all the hard line have been run throughout the car. we made an awesome find...there is this new hard brake line that you can actually bend by hand and it wont crease. this made our lives a TON simpler. no more using the bending tool.
Justin
www.grimmspeed.com