Quote:
|
Originally Posted by JC
Quote:
|
Originally Posted by MattR
Those would probably get the job done. I could aways trim the opening a bit.60 bucks + ducting, could result in a pretty slick setup...I may start on this project soon.
|
I might still have the flow data laying around, but IIRC we needed at least a 2.5" ducting to get good results. |
A 2" duct is about as large as you can go and still route the duct around the control arms and axle... any larger and it will end up being exposed to damage from below.
__________________
Is you is, or is you ain't, my con-stit-u-ints?
|