Quote:
|
Originally Posted by sperry
Quote:
|
Originally Posted by JC
Quote:
|
Originally Posted by MattR
Those would probably get the job done. I could aways trim the opening a bit.60 bucks + ducting, could result in a pretty slick setup...I may start on this project soon.
|
I might still have the flow data laying around, but IIRC we needed at least a 2.5" ducting to get good results. |
A 2" duct is about as large as you can go and still route the duct around the control arms and axle... any larger and it will end up being exposed to damage from below. |
That's what I was thinking. There is not a whole lot of room to work with under there. So that bezel may work out after all...
BTW...this thread is going nuts...34 replies in a little over an hour....nice for the tech forum