Yes, I'll know where the parts came from, but I can only hope I'll install them correctly.
Here are some new pics now that I have the bumper cover off. I'm trying to decide what parts to replace, and I don't know the names to most of the parts. Please help if you can.
These are large images to preserve detail (all but the first are 1MB each):
www.kleppinger.com/WRX-left-hood.jpg (notice how the hood isn't flush)
www.kleppinger.com/WRX-smashed-hood.jpg
www.kleppinger.com/WRX-bumper-right.jpg
www.kleppinger.com/WRX-bumper-ac-above.jpg
www.kleppinger.com/WRX-top-hood-latch.jpg
www.kleppinger.com/WRX-left-ac.jpg
www.kleppinger.com/WRX-bottom-ac.jpg
If the images are too big for you, please let me know, and I will tone them down. Detail isn't as important as help.
Here is my initial amateur analysis:
The front bumper beam and the metal underneath the AC radiator (that's what it is, right?) has to be replaced. The little plastic attachment piece with the arrow and word replace (image WRX-bumper-ac-above.jpg) also needs to be replaced. What are the names of the metal support for the AC and the plastic part? My theory is that replacing these parts should allow the hood to latch flush, but I'm not 100% sold on that theory.
The support frame under the metal support for the AC is bent slightly (you can see it in bottom-ac). What do you think? Can I just push it back and that's good enough? The support frame above the AC is also bent upward slightly, but I think it won't be a big deal. Correct me if I'm wrong.
The support beam for the hood latch is bent slightly. The latch still works. Do you think either of these need to be replaced? Do the left side and right side of the radiator/AC look ok to you? Is there anything else I'm missing that needs to be done?
Thank you very much for your help.