View Single Post
Old 2007-03-16, 11:58 PM   #19
eggeegg
EJ22
 
eggeegg's Avatar
 
Join Date: Feb 2007
Location: Reno, NV
Posts: 137
 
Car: 2006 Subaru WRX Sedan
 
Trying is the first step towards failure.
Default

I just installed 24mm adj.whiteline rear sway bars with kartboy endlinks. everything fit perfectly. it's on the stiffest setting. i drove around 20 miles and would hear a clunk sometimes when going over little dips and turning slowly. but it's not something i can reproduce all the time. i went home and tightened some nuts a little more and drove a couple more miles swerving left and right, and making hard U turns. i didn't hear any noise doing this. still only hear clunks, i think when one of my rear tires is higher than the other like slowly turning on a bump or dip. tomorrow i'll try lower settings. the below pictures were taken after driving. i went to nasioc about the clunking but the two main suggestions were to tighten stuff up a little more or reducing the stiffness. any others? oh, and i have sti pinks.


__________________
Stage 2 (XPT); Cobb DP; SPT intake, heatshield, CBE, radiator shroud, turbo shield; STI pink springs;Whiteline 20-24mm RSB; Kartboy End Links; rally pig sticker; 5zigen FN01R-C 17x8 w/ 225/45/17 RE960 AS PP; Hella twin supertones

Last edited by eggeegg; 2007-03-17 at 12:26 AM.
eggeegg is offline   Reply With Quote