Quote:
Originally Posted by norbeaster
Solid housing from shifter to derailleur and you're golden. Run it above the bottom bracket on the drive side and snug it up to the seat tube with a zip-tie so it doesn't interfere with the drive train... Then just run it along the chain stays and down-tube with a few more zip-ties and you're set. (can be neatly done if you get fancy with your zip-tie work)
It's not hack work by any means, many MTB guys opt for this style of routing as opposed to spit cables so no crap and corrosion get into the lines, especially in wet regions.
|
That might work, but of course there is a housing end lug right before the bottom bracket so it would look wonky to go around that. Will have to look at the derailleur to see if it will even take a housing end.