ECUTeK Delta Dash maps issue

[Dean]

Well, after talking to Nate, I figure I'd pass on some info about ECUTeck DeltaDash and maps.

Aparently, the consumer version does not allow us to display the maps. Aparently, even the pro version cannot even display the stock map, or any map done by anyone other than that specific version of the HW/SW.

I have asked Nate to print screen both the stock and new boost maps which should be identical for my documentation in the event of a protest. But I'm not even sure that satisfies the level of prrof required. Oh well.

Aparently as far as user tuneing is concerend, it allows us to add or subtract a percentage from the entire map, not adjust any subset of the map.

So I am torn about what maps to put in the ECU. My initial thoght was stock, and moded except boost for autocross so I could pull up A and B boost maps to prove they were unmodified as well as removing any doubt that I was swithcing to a higher map and back since it is just a defrost switch control.

Now I'm not so sure since there is no way to prove what map is actually in the ECU without going to S-Squared.

I'm still thinking abot this. What do you guys think?

[Dean]

And now they have a dashboard display which looks surprisingly like the PSI^3 one that I ordered and it switches maps, and changes user settings.... Arghhhh.

Already sent them email to see if they are the same/compatible.

http://www.ecutek.com/products/dashdisplay/